MP Electronics Controls

High Quality and Dependable Controls for Every Application


Phase Monitors

Part numbers: 001-DVM-118, 001-DVM-1212, and 001-DVM-DR are Three Phase Monitors used for Motor Protection. These Phase Monitors can be used in either a 230V or 480V panel.


Voltage Monitors

Single Phase Relay for Motor Protection.
The Over/Under Voltage Monitor is used to protect single phase equipment that is required to operate between two voltage limits.


Duplexer

The DUPLEXER (010-120-122P) is a low cost SCADA ready, Modbus RTU Protocol plug-in pump controller designed to perform level control for duplex lift station applications. Available in Simplexer operation (010-120-121P)


Time Delay Relays

The 021 Timer offers a delay on operate function. The timing range of the Adjustable Delay Timer is user specified up to one hour. The Delay on Operation can be manually set to any time within the selected range.


Intrinsically Safe Duplexer

The Intrinsically Safe Duplexer (ISD-P, ISD-D, or ISD-S) is a UL913 low cost SCADA ready intrinsically safe pump controller designed to perform level control for duplex lift station applications.


Alternators

MPE Alternating Relays are designed to perform automatic alternation motors or other types of loads, and are available in 120 VAC. The Alternator causes the loads to have even run times.


SC 100 Controller

The SC100 controller is a low cost, simple to use simplex or duplex controller for lift station liquid level control. It operates the pumps based on the selected setup parameter values and the 4-20 mA wet well level input signal.


SC1000 Controller

The SC1000 Station Controller is a UL 508 panel mount SCADA ready, Modbus RTU Protocol, pump station controller designed to perform level control in a wide range of lift station applications, including Level Pump Down/Pump Up.


SC2000 Controller

The SC2000 Station Controller is a panel mount SCADA ready, Modbus RTU Protocol, pump controller designed to perform level control in a wide range of lift station applications, including Level Pump Down/Pump Up.
The SC2000 alternates the pumps, performs lag pump delays, and provides high and low level alarms. The SC2000 has a variety of control options available in the setup menu that may be used to customize the controller for a specific application.


Submersible Transducers

The Level Monitor submersible transducer shall provide a rugged and cost-effective means to measure liquid level for wastewater pumping applications. The Submersible Pressure Transmitter is a vented Transducer with a birdcage design that comes in three base options: LM-5-40, LM-10-40, or LM-15-60; additional cable is available.


Transducer Surge Arrestors

The Transducer Surge Arrester, part number LM SURGE, shall be a Din-Rail Surge Arrestor that provides transducer protection of the 4-20 mA loop. The LM Surge shall be a thin packaged din-rail enclosed device, taking only minimal space within the control panel. The unit will be UL497B listed and have 4-20 mA protection.


Wireless Transducers

The Wireless Pressure Transducer Transmitter shall perform liquid level measurement and sends the data by radio signal to the Receiver. The wireless Level Monitor Submersible Transducer shall consist of two parts, connected by a cable; the Transmitter and the 4-20mA Level Sensor. The Transmitter shall be suspended above the liquid, and the Pressure Sensor shall be submerged in the liquid near the bottom of the tank, to give you wireless level sensing.


Battery Operated Alarm

The BOAC is a device that performs the various task required to manage a 12VDC alarm system that has an alarm strobe light and horn that must be powered by a 12V backup battery. The BOAC charges the backup battery, provides a Power Loss Alarm (when required), has a repeat cycle timer for the horn, a system push-to-test button and indication of the battery charging mode


PMR-1

The Pump Monitoring Relay (PMR1) performs both Motor Over Temperature and Seal Leakage Monitoring in one unit. 
The PMR1 is deadfront mountable so that the deadfront door need not be opened


PMR-2

The PMR2 is a direct replacement for Xylem-Flygt MiniCas product part numbers 14-407129, 14-407113, 835848, and 835857. The PMR2 performs both Motor Over Temperature and Seal Leakage Monitoring in one unit, can be powered by 120 VAC, 24 VAC, or 24 VDC, has relay contacts rated for 8 Amps at 120 VAC


Hardware

Consists of Mounting Hardware, Mounting Kits, and Sockets